Flap setting
The up/down travel of each flap (camber flaps:
FLP1/2, brake flaps: FLP3/4) can be adjusted
independently at each servo according to the wing type.
offset
call the setup screen shown below.
Up side/Down side
adjustment
Operation reference
point offset
Up side/Down side
adjustment
Operation reference
point offset
Setting method
the wing type.
Adjust the travel independently.
the reference point.
[Corresponding model type]: Airplane/
Currently selected condition name
Camber flap setting
Operation is performed via the volume
switches, etc., set for each flap control of the
function.
Brake flap to Camber flap setting
< Model menu (Airplane/Glider/Multicopter Functions) >
FLP 3
(Brake Flap)
FLP 1
(Camber Flap)
Condition group/single
mode selection (Gr. /Sngl)
(For more information, see
the description at the back
of this manual.)
Brake flap setting
The operational volume
switch is set up by "Function"
Mixing
INH ⇔ ON
The ON/OFF switch of
mixing is chosen.
*The display screen is an
the switch and tap the screen to call the
selection screen. Then, select the switch and
FLP 4
(Brake Flap)
FLP 2
(Camber Flap)
example. The actual screen
depends on the Model
Type.
131