FUTABA 16SZ Instruction Manual page 39

This is the Home screen and descriptions of its menus. Use your finger to operate the touch
screen.
Battery voltage for receivers
• In FASSTest/T-FHSS mode, it is
displayed. Receiver voltage
and Ext voltage display
The reception of the signal from the
receiver to the transmitter is shown.
Timer1, Timer2
• Timer is displayed here.
Tap the time button to start/stop the
timer. (When the screen is tapped for
1 second, timer is reset to the initial
value.)
→ (Menu)
• System
• Linkage
• Model select
Tap the button to call each Menu
screen.
System timer
• This shows the accumulated time
since the latest reset. (Each model /
Total)
(Hour):(Minute):(Second)
WARNING
Be sure to confirm the model name before flying your aircraft.
Check the battery voltage as often as possible and try to charge the battery earlier.
If the battery alarm makes a sound, land your aircraft immediately.
*You can adjust the LCD contrast by the display setting in the system menu.
40 ＜ Basic Operation ＞
BASIC OPERATION
Condition name
• The condition name
that is currently used
is displayed here.
Battery Indicator
• When the battery voltage
reaches 5.8V, the alarm will
b e e p . L a n d y o u r a i r c r a f t
immediately.
→ (Menu)
• Model
Tap the button to call Model
Menu screen.
System mode
• System(FASSTest18CH etc.)
mode is displayed here.
RF Indicator
• The model name that
is currently used is
displayed here.
User's name
Digital trim (T1 to T4)
• Trim position is displayed
here.
Model Name