Table of Contents
Advertisement
Common operations used in function setup screen
This section describes the functions often used at the function setup screen. Refer to it when setting
each function.
Pressing and holding
a value will return it
to its default setting.
Group/single mode switching (Gr/Singl)
When setting multiple flight conditions,
linking the setting contents with all conditions
(group mode) or setting independently (single
mode) can be selected. The mode can be
changed at the [Gr] item on each setup screen.
[Group/single mode switching]
Tap
The same setting contents are set to all
＜ Data ＞
170
Tapping the value setting buttons on each screen will cause value input
buttons to appear at the top of the panel.
Value input buttons display
at the top of the panel
Large change
in value
Tap
Small change
Large change
in value
Condition delay setting
Unnecessary fuselage motion generated
when there are sudden changes in the servo
position and variations in the operating time
between channels can be suppressed by using
the condition delay function of the condition
select function [Condition select].
When the delay function is set at the
switching destination condition, a delay
corresponding to that amount is applied and the
related functions change smoothly.
(When the value is tapped, the delay is reset to the initial
value.)
in value
Tap
" ▼▼ " " ▼ " " ▲ "
Advertisement
Table of Contents
