Rudder → Elevator
This function is used when you want to mix
elevator operation with rudder operation. It is used
to correct undesirable tendencies when rudder
is applied in roll maneuvers, knife edge, etc. of
acrobatic planes.
model menu and call the setup
screen shown below.
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
To set linking, tap to
the [OFF] item
Setting method
of the switch and tap the screen to call the
selection screen. Then, select the switch and
[Corresponding model type]: Airplane, general
Currently selected condition name
< Model menu (Airplane/Glider/Multicopter Functions) >
adjustment rate can be set.
Up/Down overall
adjustment at Rate A
and Rate B
Fine tuning
setting
141