Acceleration
Acceleration setting can be performed at Elevator,
only)
setting. The setting method is the same.
side and down side.
menu and call the setup screen shown
below.
When using this
function, Tap [INH].
(ON is displayed.)
The rate the angle
increases.
Setting method
can be set.
operation point is exceeded, acceleration is
performed.
150
< Model menu (Airplane/Glider/Multicopter Functions) >
[Corresponding model type]: Glider, general
Condition group/
single mode selection
(Gr. /Sngl)
The return time after operation (Damping)
can be set.
(First return)1 〜 100(Slow return)
(Acceleration doesn't function as 0.)
To next page
2/3 : Elevator → Camber
3/3 : Aileron → Rudder
Operation up to this
range will initiate
acceleration.
Act position
Current position