Table of Contents
Advertisement
◆ Speed sensor screen
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
◆ Alarm setting
↑ An upward arrow
indicates the alarm
will sound when the
speed reaches above
your set value.
↓ A downward arrow
indicates the alarm
will sound when the
speed reaches below
your set value.
The ON/OFF switch
of Speech is chosen.
2. CRSF Protocol for TBS
The T18SZ/T16SZ/FX-36 has been made compatible with
the CRSF (TBS) protocol.
■ Bidirectional communication function of CRSF is not
supported.
① [Linkage menu] → [System Type] → [Page 2/2] is
opened from the transmitter.
Tapping this will change
INH to ON and activated.
② Tap the "CRSF" button to [ON]. A signal conforming
to the CRSF standard is output from the S.BUS setting
connector (S.I/F) of the transmitter.
• Futaba Corporation shall not be responsible for any damage caused by use of this software without regard to legal foundation. Use this software based on agreement to this.
• The copyright of this software and document resides with Futaba Corporation. Redistribution without the approval of the copyright holder is prohibited. • Reverse engineering
and modification of this software is strictly prohibited.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
■ When using CRSF, the S.BUS servo setting
Look through our comprehensive collection of rc toys right away.
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
Futaba is not responsible for damage sustained by
combination with parts other than Futaba Genuine
equipment.
function and [Reload] [Register] [Change slot]
functions cannot be used. When setting S.BUS
servo and sensor, set CRSF to INH.
Airspeed
At what points (high
and low) the alarm
w i l l s o u n d i f t h e
aircraft reaches the
certain speed.
Advertisement
Table of Contents
