Table of Contents
Advertisement
Elevator → Camber
This function is used when you want to mix the
be increased.
menu and call the setup screen shown
below.
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Ailerons and flaps rate
adjustment
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
Setting method
the switch and tap the screen to call the
selection screen, and then select the switch
[Corresponding model type]: Airplane/glider, 2 ailerons or more
Currently selected condition name
Elevator → Camber
Elevator → Camber
Elevator → Camber
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
adjustment rate can be set.
selected.
Overall adjustment by
Rate A and Rate B.
The value inside the
parentheses shows the
current rudder position.
Fine tuning VR setting
Operation mode
Adjustment rate
135
Advertisement
Table of Contents
