Rudder → Aileron
This function is used when you want to mix the
ailerons with rudder operation. It is used when
rudder is applied during roll maneuvers, knife
edge, etc. of acrobatic planes. It can be used to
bank scale models, large models, etc. like a full
size plane.
and call the setup screen shown below.
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
To set linking, tap to
the [OFF] item
Setting method
of the switch and tap the screen to call the
selection screen. Then, select the switch and
adjustment rate can be set.
140
< Model menu (Airplane/Glider/Multicopter Functions) >
[Corresponding model type]:
Airplane/glider, general
RUDDER 1
Winglet
( )
at Flying wing
RUDDER 2
Currently selected condition name
AIL1
(Main Aileron)
(Main Aileron)
AIL 3
(Chip Aileron)
(Chip Aileron)
V-TAIL
RUDDER
RUDDER
Left/right overall
adjustment at Rate A
and Rate B
Fine tuning
setting
AIL 2
AIL 3
RUDDER 2
Winglet
( )
at Flying wing