Trim mix 1/2
These functions call the ailerons, elevators, and
The amount of ailerons, elevator, and flaps
a switch.
As an example Trim mix 1 can be set up for
and a slight amount of up elevator. Trim mix
2 can be used for high speed flying, with both
of down elevator.
The trim functions can be activated during
can be set to provide a smooth transition between
the two. Trim mix 2 will have priority over Trim
mix 1.
When using this
function, Tap [INH].
(ON is displayed.)
The ON/OFF switch of
mixing is chosen.
M a n u a l / A u t o m o d e
selection
Manual: Switches the
f u n c t i o n O N / O F F b y
switch
Auto: Trim mix function
call can be linked to a
stick, etc. A stick switch,
etc. separate from the
function ON/OFF switch
is set.
Condition delay setting
The offset rate of ailerons, flaps and elevators can be adjusted.
Tap to the corresponding setting item. Adjust the rate.
144
< Model menu (Airplane/Glider/Multicopter Functions) >
[Corresponding model type]: Glider, general
3. Select the [Manual] or [Auto] mode.
<Speed>
<Condition Delay>
menu and call the setup screen
shown below.
Condition delay cut
When a fine tuning VR
switch
is set, the trim rates
of ailerons, flaps and
elevators can be adjusted.
Example
.
Set the trim mix function to
*When separating the settings for each condition, move to
the [Group] item and set it to [Single].
can be set for each condition. Condition delay
operation can be interrupted and each rudder
cut switch.
*The display screen is an example. The actual
screen depends on the Model Type.
To next page
In speed
Out speed
(First) 0 〜 27 ( Slowly)
The value inside the
parentheses shows the
current rudder position.