Snap roll
This function selects the switch and rate
adjustment of each rudder, (ailerons, elevators, or
switch in the state in which the direction switch
was switched to the direction in which you want
roll in each direction can be executed by means
of independent switches.
the switch can be set so that snap roll is not
executed when, for instance, the landing
gear is lowered, even if the switch is turned on
accidentally. The snap roll switch is activated only
and call the setup screen shown
below.
Master or Single is
chosen
Snap roll
directions
[Corresponding model type]: Airplane, general
The ON/OFF switch
of snap roll is chosen.
Master mode : Direction
switches
Single mode : Snap roll
switches
< Model menu (Airplane/Glider/Multicopter Functions) >
*The snap roll up side left and right and down side left and
right direction switches are selected here.
The operation speed of each control
be changed and snap roll executed by
performed.
The safety switch is
chosen.
Aileron, elevator and
Rudder rate adjustment
To next page
Condition group/
single mode
selection (Gr. /Sngl)
In speed
Out speed
(First) 0 〜 27 ( Slowly)
145