FUTABA 16SZ Instruction Manual page 126

Activating functions for only the selected
conditions:
mode.
*Each time the button is tapped, it toggles between the Gr
and Sngl modes.
Using the offset mode:
*Each time the button is tapped, it toggles between the
Mixing and Offset modes.
1. Tap the button of the mixing you want to
set. The mixing setup screen is displayed.
Activate the function.
2. Activate the function by tapping the [INH]
button.
*Each time this button is tapped, it toggles between [INH]
and [ON/OFF].
direction switching
*An ON/OFF switch is not set even when the function is
activated.
switch, tap the [--] button to call the <Switch>
direction.
*For a description of the selection method, see [Switch
setting method] at the back of this manual.
mixing)
menu and select the master channel.
*Each time the button is tapped, it toggles between mixing
direction + and - and "OFF" (no link).
*Master channel control can be set to stick, VR, and other
simple travels which do not include End point, AFR, D/R,
mixing setting, etc. In this case, display the <Function,H/
W> screen by tapping the [Stick, Switch, Dial] button and
then select master channel side control.
1. Tap the Slave button to call the Function
menu and select the slave channel.
*Each time the button is pressed, it toggles between mixing
direction + and - and "OFF" (no link).
button on the screen.
*When mixing includes master side trim, set the Trim button
to [ON]. When mixing does not include master side trim, set
the Trim button to [OFF].
*Each time this button is pressed, it toggles between [ON]
and [OFF].
*This is effective when the master channel is set by Function.
1. Tap the curve type selection button of the
curve type you want to use to display the
selection screen. Then, select the curve you
want to use.
*For a description of the curve setting method, see the
description at the back of this manual.
1. When using the curve fine tuning function,
tap the [--] button of the Fine Tuning item to
call the <Switch> screen and then select the
lever, VR, etc. you want to use.
the description at the back of this manual.
1. When setting the servo speed, tap the speed
button. The Servo speed setup screen is
displayed.
*For a description of the servo speed setting method, see the
description at the back of this manual.
*Offset mixing changes the speed. Use the Speed In and
Speed Out buttons to readjust the speed.
The mixing switch can set a delay with a different rate at
starting and stopping.
*This function is inactive when a mixing switch is not set.
＜ Model menu (Common Functions) ＞ 127