Butterfly
This function allows powerful brake operation
by simultaneously raising the left and right
ailerons and lowering the flaps (camber flap,
This setting will allow the ailerons to be raised
while the flaps are simultaneously lowered.
Butterfly (crow) produces an extremely efficient
landing configuration by accomplishing the
following:
1. Slow the aircraft's velocity.
the tendency to tip stall.
3. Create more lift toward the center of the
When using this
function, Tap [INH].
(ON is displayed.)
Condition group/single
mode selection (Gr. /
Sngl)
The ON/OFF switch of
mixing is chosen.
Condition delay setting
When offsetting the butterfly operation
reference point, operate to the throttle
stick point you want to change and then
touch the Offset button. The reference
point displays 0%. When [Yes] is touched,
the reference point is changed. Then,
"Initialize elevator curve?" appears,
allowing you to confirm your setting.
142
< Model menu (Airplane/Glider/Multicopter Functions) >
[Corresponding model type]: Glider, 2 ailerons or more
menu and call the setup screen
shown below.
Condition delay cut
switch
item selected when operated to the position to
reference point is offset too much, unexpected
operation may be performed.
also be set.
*When servo binding occurs when setting the ailerons and
rate.
*The display screen is an example. The actual
screen depends on the model type.
To next page
The differential rate
can be adjusted.
*The display screen is an example. The actual
screen depends on the Model Type.
In speed
Out speed
(First) 0 〜 27 ( Slowly)