FUTABA 16SZ Instruction Manual page 58

H/W setting
Usually, this H/W setting is unnecessary.
Please perform this calibration only if a change at
the center of a stick should arise after prolonged use.
How to Calibrate
Tapped
The stick is set at
neutral
Stick mode
Mode 1-4 can be chosen.
But, it isn't changed until data is reset.
To change the mode the stick ratchet
must be changed. Request that this
be done by Futaba Service. (Charged
doing the calibration.
*Check after calibration to make sure that neutral is 0%, the
bottom right side is +100%, and the top left side is -100%.
＜ System menu ＞
RUD AIL RUD AIL
ELE THR THR ELE
MODE1 MODE2
AIL RUD AIL RUD
ELE THR THR ELE
MODE3 MODE4
Tapped
Full right and
full bottom
Tapped
Full left and
full top
59