FUTABA 16SZ Instruction Manual page 166

Usage example #1: Using gyro for only the rudder and adjusting sensitivity for each condition
＊ Gyro gain channel
Gyro : CH5
For the FASSTest12CH, Gyro/RUD is 6ch. The gyro sensitivity adjustment connector connects to 6ch.
Tapping here will let you
select either Normal or
AVCS.
Set gain of a rudder
Usage example #2: Using 3-axis gyro CGY750 and adjusting sensitivity for each condition
＊ Gyro gain channel
Gyro RUD : CH5 For the FASSTest12CH, Gyro/RUD is 6ch.
Gyro2 AIL : CH9
Gyro3 ELE : CH10 For the CGY750, simply connect the S.BUS; functions do not need to be set.
(For the FASSTest12CH, change Gyron/RUD to 6ch.)
Tapping here will let
you select either Normal
or AVCS for each of the
three axes.
Set gain of a rudder
This is all that is needed
for use in this case.
Because sensitivity changes for
h o v e r i n g a n d i d l e u p , p e r f o r m
switchover for each condition and
adjust sensitivity.
Set gain of an aileron
Set gain of an elevator
Because sensitivity changes for
h o v e r i n g a n d i d l e u p , p e r f o r m
switchover for each condition and
adjust sensitivity.
＜ Model Menu (Helicopter Functions) ＞
Because the
sensitivity is switched
(Sngl) per condition,
Rate 2 and Rate 3 are
not used.
This is all that is needed
for use in this case.
Because the
sensitivity is switched
(Sngl) per condition,
Rate 2 and Rate 3 are
not used.
167