Table of Contents
Advertisement
match the fuselage used.
Default setting assigns 1 model to the T16SZ. To add
new models or to call a model already set, use the Model
select function.
This is convenient when calling a model after
registering the model names in advance. (The data of up
to 30 models can be saved at the transmitter. Data can
also be saved to the optional SD card.)
The currently called model is displayed at the top
of the screen. Before flying and before changing any
If a different model type is already selected, select
helicopter with the Model type function of the Linkage
menu, and then select the swash type matched to the
helicopter.
*The Model type function automatically selects the
functions for the chosen model type. Eight swash types are
available for helicopters.
*For a description of the swash type selection, refer to the
Model type function.
per model.
The Condition select function automatically allocates
(General setting)
Note: Delete conditions you have not set
up and will not use. Otherwise you may
cause a crash.
*For a description of the condition deletion, refer to the
Condition select function.
The Normal condition is always on, and remains on
until other conditions are activated by switches.
The priority is throttle hold/idle up 2/idle up 1/normal.
Throttle hold has the highest priority.
Add other conditions, as required.
The Condition delay can be programmed for each
channel. The Condition delay is used to change the servo
throw smoothly when switching conditions.
when switch OFF)
maneuvers.
＜ Model Basic Setting Procedure ＞
47
Advertisement
Table of Contents
