Tadiran Telecom T200M Series User Manual page 59

During a Break In
After dialing a busy destination number and choosing
can hear your voice. You may press
the following soft keys.
[Xfer]
Transfer is used to converse in private with the caller party (from the original 2-way call). The called party is
released. See
[Mute]
or MUTE Mute can be activated during a Break In to mute your side, allowing you to listen to the conversation but
not speak. When this feature is activated by
[Mute]
left of
speakerphone and handset or headset. Press the toggle key again to reactivate the microphone (see
[fRls]
Forced Release enables an authorized user to end the conversation and release two ports actively connected
to each other.
[Dest]
Destination is used to converse, in private, with the 3
3-way conversation.
[Src]
Source is used to converse, in private, with the called party. The 3
way conversation.
[Wait]
Calls Waiting can be used to view the number of calls waiting for you during a conversation.
[Num]
Number is used to briefly display the two port dial numbers instead of the names.
[S/HS]
Speaker/Headset toggles between speaker and the handset operation. See
Headset on page 27
Operating the Phone
Making Internal Calls
[BrkI]
SPKR or hang up in order to allow the continuation of the call, or press on one of
B TO called number or name
 Xfer
Mute
Transfer (Xfer) on page 206
and MUTE
LED is lit red. The mute feature deactivates the microphone for your
.
(see
Upon Hearing Busy Tone on page 40)
fRls Dest
.
[Mute]
or MUTE
on/off toggle switch, a bullet appears to the
rd
party. The called party is put on hold. Press again for
rd
45 T200M Series User Guide (Coral IPx / FlexiCom)
, both conversing parties
party is put on hold. Press again for 3-
Using the Speakerphone or
page 163).