Tadiran Telecom T200M Series User Manual page 260


[BOut]
Busy Out is used to block any trunk for both incoming and outgoing calls. (This feature may be used to block
faulty trunks until the CO service is restored.) When
DEASSIGN

[Drop]
Drop No Dial is used to program an outgoing trunk to be dropped when a caller does not dial the first digit
within a system-wide time limit. The trunk is then made available to other users.

[HotI]
Hot Trunk Immediate is used to program an outgoing trunk so that the trunk automatically and immediately
connects to the system.

[HotD]
Hot Trunk Delay is used to program an outgoing trunk to automatically connect to the system, after first
digit time-out, when no dialing has taken place.

[IncO]
Incoming Only is used to reserve any trunk for incoming calls only, thereby preventing outgoing calls on
that trunk.

[OutO]
Outgoing Only is used to reserve any trunk for outgoing calls only. All incoming calls on that trunk will
continue ringing with no answer and will not be transferred to any destination.

[Rsvd]
Reserved To is used to reserve any trunk and trunk group to a specific station or Boss Group. The reservation
will prevent any other stations or Boss Group stations from making outgoing calls on these trunks.
Attendant Features
Trunk Setup Features
means the trunk line is in use by the system.
appears in the display the trunk line is blocked.
ASSIGN
246 T200M Series User Guide (Coral IPx / FlexiCom)