Transfer (Xfer) - Tadiran Telecom T200M Series User Manual

Transfer (Xfer)

You can transfer both internal and external calls to other users within your system or outside it. Transfer routes a call you
received to a specified idle station. It can also link a call you held to other ports. When Auto transfer is defined at a station,
dialing a number will automatically transfer that number, thus initial use of
subsequent actions do require pressing
Remaining procedures are the same as for a regular transfer. A call can be screened or unscreened:
•
Screened Transfer (Consultation Transfer):
• Unscreened Transfer (Direct transfer, Blind transfer, Unsupervised transfer or Cold transfer):
the call without a prior announcement or without notifying the recipient. When the destination is busy, hanging up will
cause the system to camp on (external call only) to the busy station.
Transferring an established call:
[Xfer]
1. During a call, press
2. Dial the third party destination number.
3. Choose one of the following options:
• Wait for an answer to announce the call and disconnect (screened transfer).
You can now alternate between the two parties and speak privately with one while the other is put on hold
by choosing the relevant flashing Exclude Source/Destination soft keys.
[Src]
• If is flashing, choose
[Dest]
• If is flashing, choose
[Src]
• If neither
• If you are in 3-way and you wish to converse privately again with any party; choose either the
other party will again be put on hold.
[Xfer]
• Press to release the destination (second) party and return to 2-way conversation with the source.
[fRls]
• Choose to release all parties.
[3Way]
• Choose
Station Telephony Features
Transfer (Xfer)
[Xfer]
(as defined in this manual). This feature is typically used by attendants.
You may announce the call before transferring.
or .
XFER
[Src]
to speak privately with the first party.
[Dest]
to speak privately with the second party.
[Dest]
nor are flashing, choose either
or press the CONF key to establish a 3-way call.
[Xfer]
or XFER
[Src] [Dest]
or and then converse 3-way.
206 T200M Series User Guide (Coral IPx / FlexiCom)
is not necessary, although
You may transfer
[Src] [Dest]
or and the