Appendix; Transport, Storage, Maintenance, Disposal - Danaher Motion Kollmorgen SERVOSTAR 300 Series Assembly, Installation, Setup

Kollmorgen
7

Appendix

7.1

Transport, storage, maintenance, disposal

Transport :
Packaging :
Storage :
Maintenance : — the instruments do not require any maintenance
Cleaning :
Disposal :
®
SERVOSTAR 300 Installation Manual
12/05
— only by qualified personnel
— only in the manufacturer's original recyclable packaging
— avoid shocks
— temperature -25 to +70°C, max. rate of change 20°C / hour
— humidity max. 95% relative humidity, no condensation
— The servo amplifiers contain electrostatically sensitive components,
— that can be damaged by incorrect handling. Discharge yourself
— before touching the servo amplifier. Avoid contact with highly
— insulating materials, such as artificial fabrics and plastic films.
— Place the servo amplifier on a conductive surface.
— if the packaging is damaged, check the unit for visible damage.
— In such an event, inform the shipper and the manufacturer.
— recyclable cardboard with inserts
— dimensions :
— labeling
— only in the manufacturer's original recyclable packaging
— the servo amplifiers contain electrostatically sensitive components
— which can be damaged by incorrect handling. Discharge yourself
— before touching the servo amplifier. Avoid contact with highly
— insulating materials (artificial fabrics, plastic films etc.).
— Place the servo amplifier on a conductive surface.
— max. stacking height 8 cartons
— storage temperature -25 to +55°C, max. rate of change 20°C / hour
— humidity
— storage duration
— opening the instruments invalidates the warranty
— if the casing is dirty: clean with isopropanol or similar
do not immerse or spray
— if there is dirt inside the unit: must be cleaned by the manufacturer
— dirty protective grill on fan: clean with a dry brush
— you can dismantle the servo amplifier into its principal components
— by unscrewing it (aluminum heat sink, steel housing sections,
— electronics boards)
— disposal should be carried out by a certified disposal company.
— We can give you suitable addresses on request
(HxWxD) 115x365x275mm
instrument label on outside of box
5 ... 95% relative humidity, no condensation
< 1 year without restriction
> 1 year: capacitors must be re-formed before
setting up and operating the servo amplifier.
To do this, remove all electrical connections
and apply single-phase 230V AC for about
30 minutes to the terminals L1 / L2.
Appendix
95