European Directives And Standards; Ce Conformance - Danaher Motion Kollmorgen SERVOSTAR 300 Series Assembly, Installation, Setup

Kollmorgen
2.3

European Directives and Standards

Servo amplifiers are components that are intended to be incorporated into electrical plant
and machines for industrial use. When the servo amplifiers are built into machines or
plant, the amplifier must not be used until it has been established that the machine or
equipment fulfills the requirements of the EC Machinery Directive (98/37/EC), the EC
EMC Directive (89/336/EEC) and the EC Low Voltage Directive 73/23/EEC.
Standards to be applied for conformance with the EC Machinery Directive (98/37/EC):
EN 60204-1 (Safety and Electrical Equipment in Machines)
EN 292
The manufacturer of the machine must generate a hazard analysis for the machine,
and must implement appropriate measures to ensure that unforeseen movements
cannot cause injury or damage to any person or property.
Standards to be applied for conformance with the EC Low Voltage Directive (73/23/EEC):
EN 60204-1 (Safety and Electrical Equipment in Machines)
EN 50178
EN 60439-1 (Low Voltage Switchgear Combinations)
Standards to be applied for conformance with the EC EMC Directive (89/336/EEC):
EN 61000-6-1 / EN 61000-6-2 (Interference Immunity in Residential & Industrial Areas)
EN 61000-6-3 / EN 61000-6-4 (Interference Generation in Residential & Industrial Areas)
The manufacturer of the machine/plant is responsible for ensuring that it meets the limits
required by the EMC regulations. Advice on the correct installation for EMC (such as
shielding, grounding, treatment of connectors and cable layout) can be found in this docu-
mentation.
The machine/plant manufacturer must check whether other standards or EC
Directives must be applied to the machine/plant.
2.4

CE conformance

Conformance with the EC EMC Directive 89/336/EEC and the Low Voltage Directive
73/23/EEC is mandatory for the supply of servo amplifiers within the European Commu-
nity. Product standard EN 61800-3 is applied to ensure conformance with the EMC Direc-
tive. The Declaration of Conformity form can be found on our website (download area).
Concerning noise immunity the servo amplifier meets the requirements to the 2nd envi-
ronmental category (industrial environment). For noise emission the amplifier meets the
requirement to a product of the category C2 (motor cable £ 10m).
Warning!
This product can cause high-frequency interferences in non industrial
environments which can require measures for interference suppression.
With a motor cable length from 10m onwards, the servo amplifier meets the requirement
to the category C3.
The servo amplifiers have been tested by an authorized testing laboratory in a defined
configuration, using the system components that are described in this documentation.
Any divergence from the configuration and installation described in this documentation
means that you will be responsible for carrying out new measurements to ensure confor-
mance with regulatory requirements. The standard EN 50178 is applied to ensure confor-
mance with the Low Voltage Directive.
®
SERVOSTAR 300 Installation Manual
12/05
(Safety of Machines)
(Electronic Equipment in Power Installations)
Technical description
11