Table of Contents
Advertisement
Kollmorgen
4.9
Interface for stepper motor controllers (step and direction)
This interface can be used to connect the servo amplifier to a third-party stepper-motor
controller. Parameter setting for the slave amplifier is carried out with the aid of the setup
software (electrical gearing). The number of steps can be adjusted, so that the servo
amplifier can be adapted to match the step-direction signals of any stepper controller.
Various monitoring signals can be generated.
The analog inputs are out of action.
Speed profile and signal diagram
Note:
Using an A quad B encoder provides better EMC noise immunity.
®
SERVOSTAR
300 Installation Manual
12/05
Interfaces
57
Advertisement
Table of Contents
