Connection To A Stepper Controller With 5V Signal Level (X5); Connection To A Stepper Controller With 24V Signal Level (X3) - Danaher Motion Kollmorgen SERVOSTAR 300 Series Assembly, Installation, Setup

Interfaces
4.9.1

Connection to a stepper controller with 5V signal level (X5)

This interface can be used to connect the servo amplifier to a stepper-motor controller
with a 5V signal level. It uses the SubD connector X5.
Frequency limit: 1.5 MHz
4.9.2

Connection to a stepper controller with 24V signal level (X3)

This interface can be used to connect the servo amplifier to a stepper-motor controller
with a 24V signal level. It uses the digital inputs DIGITAL-IN 1 and 2 on connector X3.
Frequency limit: 100 kHz
58
SERVOSTAR 300
SERVOSTAR 300
12/05
SERVOSTAR
Kollmorgen
®
300 Installation Manual