Encoder With Endat Or Hiperface (X1) - Danaher Motion Kollmorgen SERVOSTAR 300 Series Assembly, Installation, Setup

Interfaces
4.5.4

Encoder with EnDat or HIPERFACE (X1)

As an option, our servomotors can be fitted with a single-turn or multi-turn sine-cosine
encoder. Preferred types are the ECN1313 and EQN1325 encoders.
The encoder is used by the SERVOSTAR 300 as a feedback device for drive tasks that
require highly precise positioning or extremely smooth running.
The thermostat contact in the motor is connected via the encoder cable to X1 and
evaluated there.
If cable lengths of more than 50m are planned, please consult our customer service.
Frequency limit (A,B): 350 kHz
46
12/05
SubD 15
SERVOSTAR 300
round, 17-pin
®
SERVOSTAR 300 Installation Manual
Kollmorgen