Table of Contents
Advertisement
Interfaces
4.5.6
Incremental Encoder (X5)
An incremental encoder can be used as standard motor feedback.
Select feedback type 19 "ROD 5V with W&S". Drive executes wake&shake to calculate
the necessary start-up information for the position controller every time the 24V auxiliary
voltage is switched on.
If lead lengths of more than 50m are planned and for questions concerning the power
supply of the encoder, please consult our customer service.
The thermostat contact in the motor is connected to X1 (see p.46) or X2 (see p.43).
Frequency limit: 1.5 MHz
Don't use this feedback type with vertical load (hanging load).
48
SERVOSTAR 300
12/05
SERVOSTAR
Kollmorgen
®
300 Installation Manual
Advertisement
Table of Contents
