Focusing On The Sample - Nikon SMZ25 Instruction Manual

7

Focusing on the Sample

Focus adjustment of the sample is performed by the rotation of the focus knobs on the focus unit or focus mount. When the
remote controller or foot switch is connected, focusing can be adjusted using the focus knobs of the remote controller or the
foot pedals on the left side of the foot switch. To use the foot switch, the P2-RC Remote Controller or the P2-CTLA Control
Box must be connected.
[Focus operation]
Focus unit, focus mount, remote controller: Focus knob
The figure shows the turning directions of the focus knobs and the corresponding vertical movements of the focus mount.
• Turning the knob backward: Upward movement
• Turning the knob forward: Downward movement
Foot switch: Left foot pedal
• Rear pedal: Upward movement
• Front pedal: Downward movement
(See Chapter 8, "10.2 AZ-FSW Foot Switch.")
Notes on turning the focus knobs
• When using the focus knobs of the focus unit, focus mount or
the remote controller, do not turn (or twist) the right and left
focus knobs in opposite directions at the same time. Doing so
may cause malfunction.
• When the focus knobs of the focus unit or focus mount reach
their rotational limits for the unit's vertical movement, do not
forcibly turn it further. Doing so may cause malfunction.
Chapter 7
Specific Operations
Upward
movement
Downward
movement
Left rear pedal
(Upward movement)
Left front pedal
(Downward movement)
Focus operation
74
FL Cube FL Cube
1 2 3 4
DISPLAY DISPLAY Z-RESET Z-RESET
+
Z-SPEED Z-SPEED ZOOM STEP ZOOM STEP
Coarse Coarse Fine Fine Ex Fine Ex Fine 1x 1x 0.5x 0.5x 0.1x 0.1x
−
ZOOM ZOOM
ESCAPE ESCAPE LIMIT LIMIT
STEP STEP
ON/OFF ON/OFF ON/OFF ON/OFF
− +
ALZ ALZ
ON/OFF ON/OFF ON/OFF ON/OFF
1 x
SHR Plan apo
Do not turn the knobs in the opposite direction!
Upward
movement
Downward
movement
WD:60
2 x
SHR Plan apo WD:20