Nikon SMZ25 Instruction Manual page 30

10
Change the magnification by zooming in and out.
Press the zoom buttons on the remote controller to
change the magnification of the zooming body.
• Upper zoom button: Magnification increase
• Lower zoom button: Magnification decrease
The magnification changes in the range from 0.63x to
15.75x.
Pressing and holding the buttons causes the magnification
to change continuously.
Magnification step size
Each time the zoom step switching button is pressed,
the step size changes in the following order: 1x, 0.5x
then 0.1x. When a step size is selected, the
corresponding step LED indicator lights.
(See Chapter 8, "1.2 SMZ25 Zooming Body.")
11
Turn off the power after completing microscopy.
Turn off the P2-CTLA Control Box by pressing the power
switch to the "O" position.
Check that the power LED on the control box turns off.
Chapter 2
Microscopy Procedures
16
Upper zoom
button
(magnification
increase)
1 2
DISPLAY DISPLAY
Z-SPEED Z-SPEED
Coarse Coarse Fine Fine Ex Fine Ex Fine
ESCAPE ESCAPE
ON/OFF ON/OFF
−
ALZ ALZ
Lower zoom
ON/OFF ON/OFF
button
(magnification
decrease)
Zooming in/out
Power off
FL Cube FL Cube
3 4
Z-RESET Z-RESET
+
ZOOM STEP ZOOM STEP
1x 1x 0.5x 0.5x 0.1x 0.1x
−
Zoom step
ZOOM ZOOM
LIMIT LIMIT
STEP STEP
ON/OFF ON/OFF
indicator
+
ON/OFF ON/OFF
Zoom step
switching
button
Power LED: Off
Power switch: "O"
position