Nikon SMZ25 Instruction Manual page 32

13
Adjust the angle of the light shielding plate.
Change the angle of the light shielding plate to 45° to
prevent light reflected from the objective from entering
your eyes.
14
Turn on the HG precentered fiber illuminator and adjust the brightness.
Refer to the instruction manual for the fiber light source.
15
Adjust the focus.
→ Step 9 in "3 Procedure for Microscopy Under Diascopic Illumination"
16
Change the magnification by zooming in and out.
→ Step 10 in "3 Procedure for Microscopy Under Diascopic Illumination"
17
Turn off the power after completing microscopy.
Turn off the HG precentered fiber illuminator and P2-CTLA
Control Box by pressing their power switches to the "O"
position. Check that their power LEDs go off.
Chapter 2
Microscopy Procedures
18
Adjusting the angle of the light shielding plate
Power off
Power LED: Off
Power switch: "O"
position