Installation Of The Single/Triple Nosepiece; Installation Of The Focusing Mount Adapter - Nikon Multizoom AZ100 Instruction Manual

Installation of the Single/Triple Nosepiece

The product can be used with the AZ-NPS Single Nosepiece or AZ-NP3 Triple Nosepiece to attach an
objective (objectives). Before attaching the zoom body or the focusing mount adapter, attach a nosepiece.
The single nosepiece is attached to the bottom of the zoom body. The triple nosepiece is attached to the
bottom of the focusing mount adapter.
Attaching the single nosepiece
When only one objective is used and does not need to be
changed, attach the AZ-NPS Single Nosepiece to the lower
surface of the zoom body.
Attach the single nosepiece to the lower surface of the zoom
body with aligning the locating pin with the reference position
and secure it by tightening four screws upward from the bottom
with the hexagonal wrench (size: 2.5 mm) provided with the
zoom body.
Attaching the triple nosepiece
When the objective needs to be changed attach the AZ-NP3
Triple Nosepiece to the lower surface of the focusing mount
adapter.
1. Rotate the triple nosepiece disc part to a click-stop
position.
2. Align the locating pin with the reference hole and
insert the protruding part of the triple nosepiece into
the hole on the bottom of the focusing mount adapter.
3. Secure the nosepiece by tightening three clamp
screws near the center of the triple nosepiece
upward from the bottom with the hexagonal
wrench (size: 4 mm) provided with the zoom body.
* The clamp screws do not drop off from the triple nosepiece.

Installation of the Focusing Mount Adapter

Attach the focusing mount adapter to the pillar of the episcopic
stand.
1. Remove the two clamp screw covers on the right of
the focusing mount adapter and sufficiently loosen
the two clamp screws with the hexagonal wrench
(size: 4mm) provided with the product.
2. Align the dovetail groove of the focusing mount
adapter with the dovetail joint of the episcopic
stand pillar and slide down the focusing mount
adapter to be attached.
Be sure to slide down the focusing mount adapter as far
as it goes.
3. Tighten the two clamp screws to secure the
focusing mount adapter and attach the clamp screw
covers.
Chapter 4 Aseembly
Triple nosepiece
19
Zoom body
ON
OFF
CLIC K
Single
nosepiece
Single nosepiece installation
Focusing mount adapter
(Set to a click-
stop position)
Triple nosepiece installation
Focusing mount adapter
Dovetail joint
* For the triple nosepiece configuration,
attach the nosepiece to the focusing mount
adapter before this step.
Focusing mount adapter installation
Align the locating pin
with the reference
hole and secure the
part with four screws.
Align the locating pin
with the reference
hole and secure the
part with three screws
near the center.
Clamp screw
Attach the adapter
with aligning the
dovetail groove with
the dovetail joint.