Nikon SMZ25 Instruction Manual page 28

3
Bring an objective into the optical path.
→ Step 3 in "2 Procedure for Microscopy Under Episcopic Illumination"
4
Turn on the illumination and adjust the brightness.
Turn on the LED power ON/OFF switch at the front of the
LED diascopic illumination base.
Turn on the LED brightness control selection switch on the
left of the base to assign control to the control box, and
then control the brightness using the remote controller.
(When the LED brightness control selection switch is off,
illumination can be controlled from the base using the LED
brightness control dial.)
Press the diascopic LED ON/OFF button on the remote
controller to turn on LED illumination. Check that the LED
ON/OFF indicator lights.
Press the diascopic LED brightness control buttons to
adjust the brightness. Press [+] to increase the brightness
and [-] to decrease the brightness.
Illumination control
When the LED brightness control selection switch
is turned on, diascopic illumination can be turned
on or off, brightness can be controlled, and light
intensity can be monitored from the control box (a
P2-RC Remote Controller, or a PC (software:
NIS-Elements)). Note that illumination cannot be
controlled from the control box, even if the LED
brightness control selection switch is turned on,
unless the LED power ON/OFF switch on the base
is turned on.
To directly control the brightness using the LED
brightness control dial on the base, turn off the LED
brightness control selection switch.
For details about using the diascopic illumination
base, see Chapter 8, "8.1 P2-DBL LED Diascopic
Illumination Base."
Aperture diaphragm
The SMZ25 Zooming Body is equipped with an
aperture diaphragm. Turn the aperture diaphragm
dial counterclockwise (O side) to fully open the
aperture. (For details about using the aperture
diaphragm, see Chapter 7, "10 Using the Aperture
Diaphragm.")
5
Set the optical path to 100% to the binocular part.
→ Step 5 in "2 Procedure for Microscopy Under Episcopic Illumination"
6
Adjust the depression angle of the tilting tube.
→ Step 6 in "2 Procedure for Microscopy Under Episcopic Illumination"
7
Adjust the diopter.
→ Step 7 in "2 Procedure for Microscopy Under Episcopic Illumination"
Chapter 2
Microscopy Procedures
14
CTRL
TRL
ON OFF
LED brightness
control selection
switch
LED power ON/OFF switch
Turning on the LED power ON/OFF switch on the
base, and setting the illumination control right
to the control box
1 2
DISPLAY DISPLAY
Z-SPEED Z-SPEED
Coarse Coarse Fine Fine Ex Fine Ex Fine
ESCAPE ESCAPE
ON/OFF ON/OFF
−
ALZ ALZ
ON/OFF ON/OFF
Diascopic LED
brightness control
button
Remote on/brightness control
FL Cube FL Cube
3 4
Z-RESET Z-RESET
+
ZOOM STEP ZOOM STEP
1x 1x 0.5x 0.5x 0.1x 0.1x
−
Diascopic LED
ZOOM ZOOM
LIMIT LIMIT
STEP STEP
ON/OFF ON/OFF
ON/OFF button
+
ON/OFF ON/OFF
LED ON/OFF
indicator