Nikon SMZ25 Instruction Manual page 40

Glass stage plate handling precautions
Be very careful when handling the glass stage plate. Before attaching the glass stage plate, attach all other
components in order to avoid the risk of breaking the glass during assembly.
(1) Loosen the M4 set screw for the stage plate in the
front center of the base using the hex driver (nominal
designation: 2).
(2) Tilt the stage plate, fit it into the base, and then
tighten the fixing screw.
Note on fixing a glass stage plate in place
Do not tighten the fixing screw too much to fix the glass
stage plate in place to prevent the glass from being
damaged or broken.
Sliding mechanism
There is a clearance gap of approximately 3 mm for
the sliding mechanism, around the stage plate
when the stage is securely set.
 Attaching a fiber to the P2-DBF Fiber Diascopic Illumination Base
When using the P2-DBF Fiber Diascopic Illumination
Base, connect the fiber to the base.
Insert the hex driver (nominal designation: 2) in the fiber
fixing screw hole at the right rear side of the base and
loosen the internal fixing screw (M4 set screw). Insert the
fiber to the rear side of the base until it reaches the limit
and tighten the fixing screw.
Firmly insert the other end of the fiber into the fiber
attachment hole of the C-FLED2 LED Light Source for
Fiber Illuminator. Refer to the instruction manual supplied
with the light source for details.
 Connecting a cable to the P2-DBL LED Diascopic Illumination Base
Connect the cable to the connector on the left.
Connect the LED brightness control terminal "CTRL" with
the connector "LEDDIA" on the control box using the
CTRL cable supplied with the control box.
Connect the 12 V AC adapter to the AC adapter input
terminal that is used for the dia-illumination power supply
for the system without a control box connected.
Beware of overhang of cables
When these cables are connected, the connectors (cables) overhang to the left of the base. Be careful so that they do
not interfere with other devices such as a control box or they are not accidentally touched and disconnected while
attaching devices or performing observation.
Use the power cord specified in Chapter 5, "1 Performance Properties."
WARNING Before connecting the power cord
To prevent electric shock, be sure to turn off the power switch (press it to the "" position) at the front of the base before
connecting the power cord to the adapter.
Chapter 3
Assembling
Attaching the stage plate by tightening the screw
26
Attaching the fiber by tightening the screw
INPUT
12VDC ,
3.5A
CTRL
Connecting the LED dia-illumination
base using a cable
CTRL
ON OFF