Nikon SMZ25 Instruction Manual page 64

4
Attach a C-SSL DIA Sliding Stage.
The C-SSL can be attached to any types of bases and
stands.
(1) Loosen the M4 set screw for the stage plate on the
base or the stand using the hex driver (nominal
designation: 2) to detach the stage plate.
(2) Insert the C-SSL DIA Sliding Stage into the base or
the stand, and tighten the stage plate fixing screw.
(3) Attach the stage plate removed in step (1) to the
C-SSL DIA Sliding Stage
(4) Tighten the stage plate fixing screw of the C-SSL
DIA Sliding Stage.
5
Attach a DS camera.
(1) Attach a suitable adapter to the DS camera.
In the case of the DS camera supporting C-mount,
firmly screw the C-mount adapter in the DS camera
until it reaches the limit.
Next, attach the LV-TV TV Tube Adapter to the
C-mount adapter, and then tighten the camera
direction fixing screw on the TV tube adapter.
In the case of the DS camera supporting F-mount,
align the index marks on the F-mount adapter and
the DS camera, and turn the DS camera
counterclockwise, when viewed from the top, until it
clicks.
(2) Loosen the TV tube adapter fixing screw located on
the mount on the tube side, attach the TV tube
adapter or the F-mount adapter, and determine the
DS camera orientation, and then tighten the TV tube
adapter fixing screw.
(3) Connect the camera cable connector of the DS
camera to the connector "CAMERA" of the DS-L4
camera control unit using a dedicated camera cable.
Use two camera cable clips that are located on the
rear side of the focus unit.
Chapter 3
Assembling
F-mount adapter
TV tube adapter
fixing screw
Attaching the DS camera by tightening the screws
50
Stage plate
fixing screw
Attaching the C-SSL DIA Sliding Stage
by tightening the screw
P2-FU
M A D E I N C H I N A M A D E I N C H I N A
Camera cable clip
Stage plate
fixing screw
DS camera
supporting
C-mount
C-mount adapter
Camera direction
fixing screw
LV-TV TV
tube adapter
TV tube
adapter
fixing screw
DS camera
supporting
F-mount
Camera cable
clip