Extreme Networks ExtremeWireless AP5050D Installation Manual page 48

Figure 19: Metal sloping bracket with large conduit hole
Callout
1
Procedure
1. Attach the metal sloping bracket to the concrete floor using two anchors, nuts, and washers.
2. Attach the conduit to the metal sloping bracket.
3. Bring in the ETH1 or ETH0 cable through the conduit hole.
4. Remove the gland cap, plastic cage, and the gasket from the ETH1 port.
5. Connect the ETH0 LAN cable through the ETH0 port until it clicks into place.
If there is a ETH1 connection, insert the cable through the ETH1 gland until it locks into place into the
ETH1 port.
48 ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050D Access Point
Note
Put the removed parts onto the LAN cable to be attached to the access point later.
Connect the ETH1 or ETH0 Cable through the Metal
Description
Large conduit hole on the metal sloping bracket
Sloping Bracket