Table of Contents
Advertisement
Install the Access Point
User I/O:
•
Only the gland caps must be removed to install the ETH0 or ETH1 LAN RJ45 cable. Torque the gland
caps between 8 in-lbs. to 10 in-lbs.
•
The LAN cables must have a minimum radius of 1-in. and a 3-in. minimum drip loop. The drip loop
allows gravity to carry moisture away from the glands.
•
The console cap must be removed to install the console LAN RJ45 cable. Torque the console cap to
12 in-lbs. to 15 in-lbs.
•
If used, torque the ground screw to a minimum of 12 in-lbs.
Power or Pressure Washers:
•
The best practice is to keep a minimum distance of 24 inches between the pressure washer nozzle
and the access point.
•
Ensure that the maximum water pressure does not exceed 4000 psi.
•
Fifteen degrees (15 degrees) is the narrowest nozzle that can be used for pressure washing.
Access Point Bracket Usage and Mounting Options
The AP5050D access point can be mounted on a wall, or to a pole, which are described in the following
table.
Table 14: AP5050D Mounting Bracket Usage
Mounting bracket and
Unistrut install
part number
KT-147407-02
No
bracket; comes with
three bracket parts
KT-150173-01;
No
extension arm; used
with KT-147407-02
bracket parts
MBO-ART02
No
Wall install
Yes
Yes; place
the KT-150173-01
extension arm on
top of the 1-axis
KT-147407-02 tilt
part
Yes
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050D Access Point
Access Point Bracket Usage and Mounting Options
Pole install
Notes
Yes
For attaching to a wall or a
flat surface, use the bracket
part that has two holes. For
attaching to a pole, attach the
KT-147407-02 pole part on top
of the 1-axis tilt part
Yes; attach the
None
KT-147407-02
pole part to the
extension arm
Yes
The articulating mounting
bracket is paired with the
POLE01 bracket for pole
installations.
For wall installations, the wall
must be strong enough to
support the access point during
inclement weather
19
Advertisement
Table of Contents
