Table of Contents
Advertisement
Regulatory and Compliance Information
Instructions d'installation professionnelle
Installation
Ce produit est destine a un usage specifique et doit etre installe par un personnel qualifie maitrisant les
radiofrequences et les regles s'y rapportant. L'installation et les reglages ne doivent pas etre modifies
par l'utilisateur final.
Procedure d'installation
Consulter le manuel d'utilisation.
Warning
Avertissement: Choisir avec soin la position d'installation et s'assurer que la puissance de
sortie ne depasse pas les limites en vigueur. La violation de cette regle peut conduire a de
serieuses penalites federales.
FCC Notice (Part 15 - Class B)
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment uses, generates, and can radiate radio frequency energy and
if not installed in accordance with the operator's manual, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
•
•
•
•
Warning
Changes or modifications made to this device which are not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
FCC Radiation Exposure Statement
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Reorient or relocate the antenna of the receiving devices.
Increase the separation between this equipment and receiving equipment.
Connect this equipment into an outlet on a circuit different from that to which the
receiving equipment is connected.
Consult the dealer or an experienced radio or TV technician for help.
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050D Access Point
Instructions d'installation professionnelle
51
Advertisement
Table of Contents
