Position The Access Point Before Installation; Install The Access Point On A Wall Or To A Flat Surface - Extreme Networks ExtremeWireless AP360i ExtremeWireless AP360e Installation Manual

Install the Access Point
Table 9: Mounting bracket usage (continued)
Mounting bracket and
part number
WS-MBO-POLE01
bracket
WS-MBV-VMM vehicle
bracket (#32216)
Note
All mounting brackets are sold separately.

Position the Access Point before Installation

When you install the access point, the vent must be on the side closest to the ground, and not above
the plastic cover. You must provide a 3.0 in. (76.2 mm) drip loop on all cables.
Note
The BLE antenna on the AP360e access point comes with a dust cap. Do not remove the dust
cap until you are ready to install the antenna.

Install the Access Point on a Wall or to a Flat Surface

You can install the access point on a flat surface such as a wall using one of the following bracket
options:
•
KT-147407-02 bracket
•
KT-150173-01 extension arm
Wall install
No
Yes
ExtremeWireless™ AP360i/e Access Points
Position the Access Point before Installation
Pole install
Yes. The POLE01 bracket
can only be used with
the MBO-ART02
articulating mounting
bracket
No
Notes
If the pole diameter is
>= 1.0 in. (25.4 mm), use
a small cable clamp. If
the pole diameter is
between 5.0 in. - 7.0 in.
(127.0 mm - 178.0 mm),
use a large cable clamp.
For any other pole
diameter, provide your
own stainless steel cable
clamp. The band must
be 0.5 in. (12.7 mm)
wide.
The VMM vehicle
bracket has four parts:
• Flat plate with
thumbscrews
• Stiffener plate 1
• Stiffener plate 2
• Vehicle attach
assembly plate
17