Install The Access Point On A Wall Or To A Flat Surface; Install The Access Point To A Flat Surface Using Kt-147407-02 Flat Part And 1-Axis Tilt Part - Extreme Networks ExtremeWireless AP460i Installation Manual

Install the Access Point

Install the Access Point on a Wall or to a Flat Surface

You can install the access point on a flat surface such as a wall using one of the following bracket
options:
•
KT-147407-02 bracket
•
KT-150173-01 extension arm
•
MBO-ART02 10 in. 2-axis articulating mounting bracket
•
WS-MBV-VMM vehicle bracket (#32216)
Note
The wall install options are applicable to both internal and external antenna model outdoor
access points.
Install the Access Point to a Flat Surface Using KT-147407-02 Flat Part and 1-Axis
Tilt Part
Before You Begin
The KT-147407-02 bracket has three bracket parts:
•
Flat part
•
1-axis tilt part
•
Pole part
For a flat surface installation, you require the flat part and the 1-axis tilt part.
Figure 5: KT-147407-02 bracket flat part
Install the Access Point on a Wall or to a Flat Surface
ExtremeWireless™ AP460i/e Access Points 19