Install The Access Point Using Kt-150173-01 Extension Arm - Extreme Networks ExtremeWireless AP5050D Installation Manual

Install the Access Point
3. Using the KT-150173-01 extension arm as a template, mark and drill four hole centers on a flat
surface.
The holes must be within the circular cuts in the end of the flange.
4. Attach one end of the KT-150173-01 extension arm to the 1-axis tilt bracket using two hex-head M12
stainless-steel screws and two hex-head M12 stainless-steel nuts through the two large circular holes
on the KT-150173- 01 extension arm.
5. Attach the KT-150173-01 extension arm, that now has the access point mounted on the other end, to
a flat surface using four M6 size hex-head screws.
Use screw-in anchors with the four M6 hex-head screws when you mount the bracket on a wood
surface and use concrete anchors for concrete surface.

Install the Access Point Using KT-150173-01 Extension Arm

Before You Begin
Obtain the following hardware:
•
KT-150173-01 extension arm
•
Four M6 screws
•
Four M6 hex-head screws
•
One access point
About This Task
Install your access point with an extension arm if a standoff distance is required. The KT-150173-01
extension arm provides a minimum standoff distance of twelve inches and helps avoid interference with
the antennas.
Install the Access Point Using KT-150173-01 Extension
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050D Access Point
Arm
25