Table of Contents
Advertisement
Install the Access Point on a Pole Using KT-147407-02
Bracket Parts and KT-150173-01 Extension Arm
4. Insert the stainless-steel cabe clamp through the long slots on the pole bracket.
5. Position the cable clamps on the pole bracket around a pole and attach the pole bracket
6. Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 11
in-lbs.
Install the Access Point on a Pole Using KT-147407-02 Bracket Parts and
KT-150173-01 Extension Arm
Before You Begin
The following hardware is required for pole installation using KT-147407-02 bracket parts and
KT-150173-01 extension arm:
•
Flat part of the KT-147407-02 bracket
•
1-axis tilt part of the KT-147407-02 bracket
•
Pole part of the KT-147407-02 bracket
•
KT-150173-01 extension arm
•
Six M6 screws
•
Four hex-head M12 stainless-steel screws
•
Four hex-head M12 stainless-steel nuts
•
Two 0.5" wide stainless-steel cable clamps
•
One access point
About This Task
Install the access point on a pole with all three KT-147407-02 bracket parts and KT-150173-01 extension
arm
Procedure
1. Attach the flat part and the 1-axis tilt part of the KT-147407-02 bracket to the access point.
For instructions on how to attach the bracket parts, see
Bracket Parts and KT-150173-01 Extension Arm
2. Align the circular holes on one end of the KT-150173-01 extension arm against the large holes on the
1-axis tilt bracket.
3. Attach the KT-150173-01 extension arm to the 1-axis tilt bracket by using two hex-head M12 stainless-
steel screws and two hex-head M12 stainless-steel nuts.
34
ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050D Access Point
Install the Access Point Using KT-147407-02
on page 24.
Install the Access Point
Advertisement
Table of Contents
