Position The Access Point Before Installation; Install The Access Point On A Wall Or Flat Surface - Extreme Networks ExtremeMobility AP460i Installation Manual

Position the Access Point before Installation

When you install the access point, the gore vent must be on the side closest to the ground, and not
above the plastic cover. You must provide a 3-inch drip loop on all cables.
Note
The sensor and BLE antennas come with dust cap on them. Do not remove the dust cap until
you need to install the antennas.

Install the Access Point on a Wall or Flat Surface

You can install the access point on a flat surface such as a wall using the following brackets:
•
KT-147407-02 bracket
•
KT-150173-01 extension arm
•
MBO-ART02 10" 2-axis articulating mounting bracket
•
WS-MBV-VMM vehicle bracket (#32216)
Note
The wall install options are applicable to both internal and external antenna model outdoor
access points.
Install the Access Point to a Flat Surface Using KT-147407-02 Flat Part and 1-
Axis Tilt Part
The KT-147407-02 bracket has three bracket parts; flat part, 1-axis tilt part, and the pole part. For this
installation, you require the flat part and the 1-axis tilt part.
Figure 4: KT-147407-02 bracket flat part
ExtremeMobility AP460i/e Outdoor Access Points
Install the Access Point
14