Connect The Eth1 Or Eth0 Cable Through The Service Panel Base - Extreme Networks ExtremeWireless AP5050D Installation Manual

Connect the ETH1 or ETH0 Cable through the
Service Panel Base
The ETH1 or ETH0 cable can be connected through the front or the rear hole on the side of the service
panel base
About This Task
The ETH1 or ETH0 cable is connected through the front or the rear holes on the sides of the service
panel base.
The following hardware is required to attach the ETH1 or ETH0 cable through the rear hole of the
service panel base:
•
ETH1 or ETH0 cable
•
One blank conduit cover to cover the front hole on the side of the service panel base
•
One 3/4 in. or 1/2 in. conduit cover, depending on the circumference of the ETH1 or ETH0 cable
•
Service panel base
•
Sevice panel top
44 ExtremeWireless™ 802.11ax Wi-Fi 6E Outdoor AP5050D Access Point