Energy Management; Load Profile; Energy Profile; Tariffs - Siemens SICAM Q100 7KG95 Series Manual

8.5

Energy Management

Load Profile

8.5.1
Table 8-9
Parameter
Subperiod time
Number of subperiods
Synchronization source
Kind of used reactive power

Energy Profile

8.5.2
Table 8-10
Parameter
Enable energy profile
Interval

Tariffs

8.5.3
Table 8-11
Parameter
Synchronization source
The following parameters are available only when Synchronization source is set to Calendar.
Season 1 Start
Season 1 End
Number = 1: Fixed Block method: The lengths of the subperiod and of the measuring period are identical; Number = 2 to 5: Rolling
54
Block method; Length of the subperiod: The length of the subperiod is an integer part of a full hour; Length of measuring period: The
length of the measuring period cannot be configured directly. It is defined as the product of the length of the subperiod and the
number of subperiods: Length of measuring period = n x length of subperiod; n = number of subperiods
In this case, the protocol Modbus TCP can control tariff 1 to tariff 8. Refer to the System Manual SICAM Q100, chapter 2.2.7.18
55
Register 0154: Tariffs (read and write), order number E50417-C1040-C522.
56 This synchronization source can only control tariff 1 or tariff 2.
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A8, Edition 09.2020
Settings for Load Profile
Default Setting
15 min
54 1
Internal clock
Q1
Settings for Energy Profile
Default Setting
No
15 min
Settings for Tariffs (TOU)
Default Setting
Protocol
01-01
06-30
Operational Indications and Operating Parameters
Setting Range
1 min to 6 min in 1-min steps,
10 min, 12 min, 15 min, 20 min, 30 min, 60 min
1 to 5
None
Protocol
Binary input 1 to 2
Internal clock
Q1
Qn
Qtot
Setting Range
No
Yes
15 min
30 min
45 min
1 h
24 h
Setting Range
55
Protocol
56
Binary input 1
Binary input 2
56
Calendar
01-01 to 12-31
01-01 to 12-31
8.5 Energy Management
357