Siemens SICAM Q100 7KG95 Series Manual page 220

Device Functions
2.10 Other Device Functions
Parameter
Start of DST
End of DST
Additional Parameters if the Source is Ethernet NTP (Modbus TCP and IEC 61850)
Primary NTP server IP Address
Secondary NTP server IP
Address
Error indication after
Additional Parameters if Source is Fieldbus
Error indication after
•
After the parameterization, click Send.
•
In the navigation window, select Finish configuration and click Activation.
NOTE
i i
NTP protocol: The SNTP client in the device is activated or deactivated during configuration of the time
synchronization. Ethernet NTP can be selected as Source time synchronization. Associated IP addresses
of the NTP servers can be entered.
SNTP Diagnosis
If you select Ethernet NTP as the Source time synchronization, configure the relevant parameters, and acti-
vate them, the entry SNTP is visible under the Diagnosis menu in the navigation window of Maintenance.
220
Default Setting
March
Last week
Sunday
2:00 AM
October
Last week
Sunday
3:00 AM
0.0.0.0
0.0.0.0
10 min
10 min
Setting Range
January to December
First week
Second week
Third week
Fourth week
Last week
Sunday to Saturday
12:00 AM to 11:00 PM
(in increments of 1 h)
January to December
First week
Second week
Third week
Fourth week
Last week
Sunday to Saturday
12:00 AM to 11:00 PM
(in increments of 1 h)
Any
No polling of the NTP server if 0.0.0.0 is entered
Any
No polling of the NTP server if 0.0.0.0 is entered
2 min to 120 min
2 min to 120 min
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A8, Edition 09.2020