Led Indications - Siemens SICAM Q100 7KG95 Series Manual

LED Indications

5.1.3
Table 5-1
LED
Table 5-2
LED Combination
No Operation
Normal Operation
Fallback Mode
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A8, Edition 09.2020
Meaning of LEDs
Description
LED is off.
LED is on.
LED is flashing (0.2 s on, 0.2 s off).
LEDs according to configuration
If an indication is assigned to an LED (see chapter
•
Indication off → LED off
•
Indication on → LED on
•
Indication invalid → LED is flashing (0.5 s on and 0.5 s off)
Indication of LEDs
Description
Device is switched off.
Device is switched on, but firmware is not loaded
or
Device is in startup phase.
The device uses the IP address configured by the user or received via DHCP.
H1 and H2 LEDs are according to configuration.
Normal operation with default IP address
Default IP address is requested by pressing the F4 softkey during normal
operation.
Double IP address has been detected in the network.
The device is in operation but cannot be reached via Ethernet.
Solve this network configuration issue and restart the device.
Each device must have a unique IP address.
An IP address request via DHCP is in progress.
ERR = off and H1 to H2 LEDs according to configuration
RUN LED stops flashing when IP address is received.
The device uses the IP address configured by the user or received via DHCP.
The device runs into the Fallback mode after an unresolvable error in
normal operation occurs or by pressing the F4 softkey during device startup.
Fallback mode with default IP address
Default IP address is requested by pressing the F4 softkey during fallback
mode.
Troubleshooting, Repair, and Fallback Mode
5.1 Failures and LED Displays
8.2.4 LEDs):
325