Device Design - Siemens SICAM Q100 7KG95 Series Manual

1.3

Device Design

Mechanical Design
The device is designed for panel flush-mounting. The electrical modules are installed in a plastic case with the
dimensions (W x H x D) 96 mm (3.78 inch) x 96 mm (3.78 inch) x 100 mm (3.94 inch).
The front side of the device contains the display, 4 softkeys located under the display, and 4 LEDs. The LEDs
H1 to H2 and the red ERROR LED can be parameterized. The green LED RUN signals the correct operation of
the device.
All inputs and outputs are located at the rear of the device, as well as the communication interfaces and the
power-supply input. A lithium battery is located under the removable cover of the battery compartment. The
exchangeable 2 GB microSD card is inserted behind a removeable cover.
The device has 2 clips at the top and at the bottom or both sides for assembly in a switch panel. For devices
according to degree protection IP54, see chapter
[le_Q100_front side, 1, --_--]
Figure 1-1
(1) LED RUN
(2) LED ERROR for error configuration
(3) Battery compartment
(4) Ethernet interface Z
(5) Display
(6) Default IP address and default subnet mask
(7) LED H1 for free configuration
(8) Softkeys F1 to F4
(9) LED H2 for free configuration
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A8, Edition 09.2020
Layout of SICAM Q100 – Front Side
4.3 Assembly.
Introduction
1.3 Device Design
25