The RADIUS protocol is deactivated by default. The parameters for the RADIUS server are available and can be
configured only after you activate the RADIUS protocol.
The device supports 2 RADIUS servers:
•
Primary RADIUS server
•
Secondary RADIUS server
If both RADIUS servers are configured, the device sends the authentication request to the primary RADIUS
server first. The device sends the request to the secondary RADIUS server only if the primary RADIUS server is
not reachable.
To set the RADIUS server in the Configure tab, proceed as follows:
•
In the navigation window, select Administrative and click Account management.
[sc_RADIUS server, 2, en_US]
Figure 3-9
•
Set the RADIUS server according to the following table.
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A8, Edition 09.2020
Configuration Tab, Remote Authentication
Security
3.2 Account Management
257