Troubleshooting, Repair, and Fallback Mode
5.1 Failures and LED Displays
5.1
Failures and LED Displays
General Inspection
5.1.1
Visual Inspection
If function failures occur, first check the device visually. Observe the following points when inspecting the
device visually:
•
Correct installation of the device at the intended location as described in chapter
•
Compliance with the environmental conditions specified in chapter
Climatic Stress Tests
•
Correct connection of supply voltage and grounding conductors according to chapter
Connection
•
Correct connection of measuring and communication lines according to chapter
Function Checks
Additionally, check the following aspects:
•
Functioning of the display according to chapter
display
•
Correct functioning of peripheral devices (for example connected PC, series-connected current trans-
formers)
•
Compliance with the system requirements specified in chapter
•
Compliance with the access rights according to chapter
•
Compliance with the commissioning sequence of the device according to chapter
•
Evaluation of the LED failure indications, see chapter
5.1.2
Troubleshooting and Repair
General Troubleshooting
You are not authorized to do troubleshooting for the defective device beyond the measures described in
chapter
5.1.1 General Inspection
SICAM Q100 which can only be replaced by the manufacturer according to the guidelines for Electrostatic
sensitive devices (ESD).
If you suspect any damage on the device, Siemens recommends sending the entire device to the manufac-
turer. For this purpose, it is best to use the original transport packaging or similar packaging.
Troubleshooting Based on Error Messages
NOTE
i
i
Error messages are service information that you provide upon request to the service department in case of
an error.
The error messages can be saved as described in chapter
tion, section File download → Save.
The error messages can be printed as described in chapter
tion, section File download → Open.
324
4.14 Operation via Display
5.1 Failures and LED Displays
and make repairs on your own. Special electronic modules are inserted in
4.13.2.7 Starting the User Interface during Opera-
4.13.2.7 Starting the User Interface during Opera-
4.3 Assembly
7.1.4 Environmental Conditions and
4.5 Electrical Connection
and good visibility of the
4.8 System Requirements
4.9 Access Rights
4.11 Commissioning
SICAM, SICAM Q100 7KG95xx, Manual
E50417-H1040-C522-A8, Edition 09.2020
4.5 Electrical