Table of Contents
Advertisement
No.
4
Vibration Sensor
8.5 CONDITIONS OF CRANK DISCONNECT SELECTION
No.
0
Engine Speed
1
Oil pressure
2
Engine Speed + Oil Pressure
NOTES:
a)
There are 2 conditions to make starter disconnected with engine. Engine speed and oil pressure can be used
separately. We recommend that oil pressure should be used with speed sensor together, in order to make the
starter motor separate with engine immediately and can check crank disconnect exactly;
b)
Speed sensor is the magnetic equipment installed in starter for detecting flywheel teeth;
c)
When set it speed sensor, users must ensure that the number of flywheel teeth is the same as settings, otherwise,
"over speed shutdown" or "under speed shutdown" may be caused;
d)
If unit doesn't have speed sensor please don't select corresponding items, otherwise, "start fail" or "loss speed
signal" may be caused;
e)
If unit doesn't have oil pressure sensor, please don't select corresponding items.
9 PARAMETERS SETTING
9.1 MENU LIST
Press
key and enter into setting menu after controller is power on. The menu list is as below:
Parameters Set
Lock Set
Override Mode
DPF Regeneration
Language
LCD Backlight
Event Log
Black Box
Module Info
ACC7200 Air Compressor Controller User Manual
Description
0: Not used
1: Custom Res Curve
2: Custom (4-20)mA Curve
3: Custom Volt Curve
4-15 Reserved
Table 14 Crank Disconnect Conditions
Setting Description
Remark
Defined resistance's
range is (0~1)KΩ, default
is Not Used; Users can
select corresponding
curve by themselves;
If pre-set sensor channel
doesn't support current,
and voltage type, then
curve type item 2 and 3
display "Reserved".
Page 57 of 77
Advertisement
Table of Contents
