Parameters Setting; Parameters Setting Mode - Smartgen HAT162 User Manual

8. PARAMETERS SETTING

8.1 PARAMETERS SETTING MODE

In manual mode, enter into parameters setting mode by pressing
indicator and gen status indicator
to see the following picture.
NOTE: At this moment, press
8.2 PARAMETERS SETTING
When it entered into parameter setting mode, users can adjusting parameters by pressing
And ④ and ⑦ LEDs are illuminated. ①, ②, ③, ④ indicators mean setting items numbers (currently
item number is 1); ⑤, ⑥, ⑦ indicators mean these parameter values (currently parameter value is 1).
Configurable parameter list please check "Table 6 Parameters Definition and Range Table (1)" of item
7.
Specific settings are as below:
1) Select setting number which needs to adjust by pressing
2) Enter into setting status by pressing
3) After set this parameter by pressing
4) Hold and press
which means parameters are all saved and then it will return to normal mode.
NOTE: See "Table 8 Parameter Value Comparison" for the values corresponding of LED indicators.
HAT162 ATS Controller User Manual
flash; ①, ②, ③, ④ indicators illuminate. LED numbers please
Fig.3 Parameter Configuration
will return to normal mode after LED flash.
and ⑦ indicator flashes;
and
after all parameters are configured, and release
and ;
, and press the key to save the value.
for 8s and manual/auto
when all LEDs flash,
Page 13 of 21
.