Smartgen HGM410DC User Manual page 15

Pin Function
12. Oil Pressure Sensor
13. Current IA
14. Current IB
15. Current IC
16. Current COM
17. Rotate Speed Sensor
18. CHARGER(D+)
19. Aux. Output 4
20. Aux. Output 5
21. Aux. COM
22. Gen AC Voltage U
23. Gen AC Voltage V
24. Gen AC Voltage W
25. Gen AC Voltage N2
26. RS485 A(+)
27. RS485 B(-)
28. RS485 SCR
29. B1-
30. B1+
NOTE: LINK interface is parameters programmable interface that can be programmed by PC
using an SG72 adapter. If there is need to remote control the genset, please use the SG485 module
produced by our company.
HGM410DC Genset Controller
HGM410DC Genset Controller User Manual
Cable Size
resistance sensor.
Connect
2
1.0mm
resistance sensor.
Outside connected to secondary coil of current
2
1.5mm
transformer(rated 5A)
Outside connected to secondary coil of current
2
1.5mm
transformer(rated 5A)
Outside connected to secondary coil of current
2
1.5mm
transformer(rated 5A)
2
1.5mm See INSTALLATION in this manual.
Connect to rotate speed sensor, shielding line is
2
0.5mm recommended. The other terminal needs to
connect to B-.
Connect to charging starter's D+ terminal. If there
2
1.0mm
is no this terminal, then be hang up.
The combination of terminal 19 and 21 is relay
2
1.0mm
normally open contact; rated 5A; Voltage free.
The combination of terminal 20 and 21 is relay
2
1.0mm
normally open contact; rated 5A; Voltage free.
2
1.5mm Common terminal of auxiliary output 4 and 5.
Connected to U-phase of generator (2A fuse is
2
1.0mm
recommended)
Connected to V-phase of generator (2A fuse is
2
1.0mm
recommended)
Connected to W-phase of generator (2A fuse is
2
1.0mm
recommended)
2
1.0mm Connected to N-wire of generator.
2
0.5mm
Connect to remote monitoring RS485 COM, A and
2
0.5mm B connect to communication wire, SCR connect to
2
0.5mm communication shielding line.
2
1.0mm
Connect to battery voltage.
2
1.0mm
2015-11-12
Description
to oil pressure
Version 1.0 Page 16 of 34