Table of Contents
Advertisement
12 FIXING CLIPS
Controller is panel built-in design; it is fixed by clips when installed.
1)
Withdraw the fixing clip screw (turn anticlockwise) until it reaches proper position.
2)
Pull the fixing clip backwards (towards the back of the module) ensuring two clips are inside their
allotted slots.
3)
Turn the fixing clip screws clockwise until they are fixed on the panel.
Note: Care should be taken not to over tighten the screws of fixing clips.
13 OVERALL DIMENSION AND PANEL CUTOUT
HGM410DC Genset Controller
HGM410DC Genset Controller User Manual
2015-11-12
Version 1.0
Page 32 of 34
Advertisement
Table of Contents
